Æ 6.02 – Understanding Pressure at the Puck

الرجاء إنشاء حساب ل دورة قبل البدء بالدرس

As working baristas, we’re often used to thinking of pressure as a fixed input from the machine. When the pump is turned on, the machine’s pressure gauge shows us the pressure the pump produces, which is typically set somewhere around 9 bars.

The actual amount of pressure applied to the القُرص, however, is a different matter. To understand the discrepancy, we first need to understand the relationships among pressure, flow, and resistance.



The Pressure Drop

The first concept to understand is that flow through a tube depends not on the pressure, but on the change in pressure along its length — called the pressure drop. Water flows from an area of high pressure to an area of low pressure, so the pressure drop is necessary to create flow.

Pressure drop and flow. In a sealed pipe (image above), the pump on the left generates 9 bars of pressure. The entire pipe reaches 9 bars of pressure, but no flow takes place because there is no pressure drop. When the pipe is opened (image below), the pressure at the exit is released and becomes the same as atmospheric pressure (0 bar). The pump still generates 9 bars of pressure, so the pressure drops along the length of the pipe, from 9 bars down to atmospheric pressure. Water flows from high pressure to low pressure.

In an espresso machine the water is pressurised at the pump, flows through the pipework in the machine to the القُرص, and exits from the القُرص out into the cup. For this flow to continue, a pressure drop must occur throughout the whole system. This means that the placement of the pressure gauge in the machine is important — if it is positioned close to the pump, the pressure will measure higher; if it is positioned close to the القُرص,

العودة إلى: المهارات الاحترافية لإعداد الإسبريسو - (قيد الترجمة) > Pressure

You have Successfully Subscribed!